How to make a "robotic hand"



We are searching data for your request:

Forums and discussions:
Manuals and reference books:
Data from registers:
Wait the end of the search in all databases.
Upon completion, a link will appear to access the found materials.

You are going to need corrugated cardboard.

The size of your hand.

Draw your first four fingers.

Then your thumb.

With your knife cut through the lines.

This is what it should look like when you finish cutting.

Take your knife and instead of cutting through just apply enough pressure so that the cardboard dents. ⚠️Be careful not to cut all the way.⚠️

After denting the fingers carefully bend them like so.

It should look like this.

The next step is to cut straws smaller than the finger segments. And tape them.

Now feed a string segment through the straws.

Now tape the the string to the top of the finger.

Poke a hole in the center of the hand.

Feed the strings through the hole.


Watch the video: Make a Simple Robotic Arm From Cardboard. DIY


Previous Article

How to remove a vanity counter

Next Article

How to make custard cupcakes from icecreamintherain.com